Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Alvarado CSG
Summary of Contents for Alvarado CSG
- Page 1 CSG/SSG/CFG BI-DIRECTIONAL WAIST HIGH SECURITY GATE CSG/SSG Installation and Maintenance Instructions Alvarado Manufacturing Company, Inc. 12660 Colony Street, Chino, CA 91710 Telephone: (909) 591-8431 Fax: (909) 628-1403 support@alvaradomfg.com www.alvaradomfg.com PUD3570R2-0...
-
Page 2: Table Of Contents
This symbol is used in this manual to designate useful information for the installer and operator. NOTE Please read these instructions. For questions, please contact Alvarado at (909) 591-8431, Monday – Friday 6:30am to 4:30 PST. Please read this manual completely before installing or operating the product. Safety Precautions WARNING •... -
Page 3: Installation Tools
(Qty 4) Before You Begin This installation manual is applicable to the following gate models: CSG, SSG, CFG. This manual focuses on the CSG/SSG for the basis of instruction; however, most steps are identical across models. Any differences will be called out as applicable. -
Page 4: Site Preparation
CSG/SSG/CFG Installation and Maintenance Instructions Site Preparation Use only skilled technicians for site preparation and installation of the gate using Alvarado’s instructions. Slab Requirements • Install gate on a solid, level concrete slab with a minimum thickness of 4". •... -
Page 5: Installation Instructions
CSG/SSG/CFG Installation and Maintenance Instructions Installation Instructions Anchoring the Hinge Post Fig. 4 Fig. 4 Marking Centerlines 1. Once the installation location has been determined, snap a chalk line on the floor to mark the gate centerline [Figure 4]. 2. Mark the hinge post center and end-of-gate locations (approximately 41.5") along the centerline. -
Page 6: Installing The Directional Adapter Bracket
CSG/SSG/CFG Installation and Maintenance Instructions Installing the Directional Adapter Bracket Alvarado's default configuration for the CFG, CSG, and SSG gates is bi-directional (without the directional adapter bracket installed). To configure a left- or right-hand only swing, install the directional adapter bracket per the instructions below: 14. -
Page 7: Installing The Protective Pads (Cfg Only)
Exterior Cleaning The frequency of exterior cleaning will depend on the environment in which the gate is installed. Alvarado recommends cleaning every (60) days for gates installed indoors or in temperate climates. If a stainless steel gate (SSG) is installed outdoors, clean the gate on a more frequent basis. A best practice for preventing build-up of contaminants is to wipe down the gate with a damp cloth on a daily basis. -
Page 8: Maintenance
If the gate overtravels, refer to the Adjusting Swing Limit section on page 6. Appendix A - Signage The CSG,SSG, and CFG gates are equipped with two infill bars for mounting signage. Fig. A1 Fig. A1 SSG with Custom Sign Fig. - Page 9 This page intentionally left blank.
- Page 10 12660 Colony Street, Chino, CA 91710 Telephone: (909) 591-8431 Fax: (909) 628-1403 support@alvaradomfg.com www.alvaradomfg.com © 2013 Alvarado Manufacturing Company, Inc. This work may not be reproduced, published or redistributed, in whole or in part, without the express prior written permission of Alvarado.
Need help?
Do you have a question about the CSG and is the answer not in the manual?
Questions and answers