Assigning An Ip Address To A Vlan - Dell Networking S3100 Series Getting Started Manual

interface vlan vlan-id
2. Enable an interface to include the IEEE 802.1Q tag header.
INTERFACE mode
tagged interface
This command is available only in VLAN interfaces.
3. Move untagged interfaces. Access INTERFACE VLAN mode of the VLAN
to which you want to assign the interface.
CONFIGURATION mode
interface vlan vlan-id
4. Configure an interface as untagged.
INTERFACE mode
untagged interface
This command is available only in VLAN interfaces.
To view which interfaces are tagged or untagged and to view which VLAN the
interfaces belong, use the show vlan command. To view just the interfaces
that are in Layer 2 mode, use the show interfaces switchport
command in EXEC Privilege mode or EXEC mode.

Assigning an IP Address to a VLAN

VLANs are a Layer 2 feature. For two physical interfaces on different VLANs to
communicate, assign an IP address to the VLANs to route traffic between the
two interfaces.
The shutdown command in INTERFACE mode does not affect Layer 2 traffic
on the interface.
NOTE: You cannot assign an IP address to the default VLAN, which, by
default, is VLAN 1. To assign another VLAN ID to the default VLAN, use
the default vlan-id vlan-id command from the configuration
mode.
• Access INTERFACE VLAN mode of the VLAN to which you want to assign
the IP address.
INTERFACE mode
ip address ip-address mask [secondary]
Installing the Software
23