Synology RackStation RS2818RP+ Hardware Installation Manual page 11

4 Put back the rear top cover you lifted in step 2.
a Align the round dots at the side of rear top cover with the slots on the chassis' edge, and push the rear top
cover back in position.
b Put back and fasten the screw you removed in step 2-a.
To make sure RackStation recognizes the new memory capacity:
1 Install DiskStation Manager (DSM). (See the next chapter for more information.)
2 Log in to DSM as admin or a user belonging to the administrators group.
3 Check Total Physical Memory
If your RackStation does not recognize the memory or does not start up successfully, confirm that the memory is
installed correctly.
To remove the RAM Module:
1 Follow step 1 and 2 of the "To install the RAM module" section to shut down your RackStation, disconnect the
cables, and then remove the rear top cover.
2 Disengage the memory retaining clips by pushing them outwards, and the module will pop out of the slot.
3 Follow step 4 of the "To install the RAM module" section to put back the top cover.
11 Chapter 2: Hardware Setup
in Control Panel > Info Center.