Table of Contents
Advertisement
Remove the power button board
Make sure the following FRUs (or CRUs) have been removed.
"Remove the service door" on page 30
"Remove the Solid State Drive (SSD)" on page 30
"Remove the Hard Disk Drive (HDD)" on page 32
"Remove the lower case" on page 35
"Remove the battery pack" on page 36
"Remove the memory modules" on page 39
"Remove the Wi-Fi card" on page 40
"Remove the heat sink" on page 41
"Remove the fans" on page 42
"Remove the system board" on page 48
Step 1.
Detach the connector.
Figure 44. Detach the connector
Step 2.
Remove the screw.
.
Chapter 4
Removing a FRU or CRU
51
Advertisement
Table of Contents
