Section 8 − Stick Welding (Smaw) Guidelines - Hobart Welding Products STICKMATE 235 AC Owner's Manual

SECTION 8 − STICK WELDING (SMAW) GUIDELINES
8-1. Stick Welding Procedure
Tools Needed:
2
1
OM-254 339 Page 30
Equipment Needed:
5
4
7
Constant Current
Welding Power Source
3
6
!
Weld current starts when
electrode touches work-
piece.
!
Weld current can damage
electronic parts in vehicles.
Disconnect both battery
cables before welding on a
vehicle. Place work clamp
as close to the weld as
possible.
.
Always wear appropriate per-
sonal protective clothing.
1 Workpiece
Make sure workpiece is clean be-
fore welding.
2 Work Clamp
3 Electrode
A small diameter electrode re-
quires less current than a large
one. Follow electrode manufactur-
er's instructions when setting weld
amperage (see Section 8-2).
4 Insulated Electrode Holder
5 Electrode Holder Position
6 Arc Length
Arc length is the distance from the
electrode to the workpiece. A short
arc with correct amperage will give
a sharp, crackling sound.
7 Slag
Use a chipping hammer and wire
brush to remove slag. Remove
slag and check weld bead before
making another weld pass.
stick 2010−02 − 151 593