Table of Contents
Advertisement
8-3. DATE AND TIME
Set the current date and time in this device.
Item
Description
Time zone settings
Set the time difference with UTC (Universal Time, Coordi-
nated) and the region where this device is used.
Date and time set-
Set the current date and time. Synchronize with the NTP
tings
server on the network and put a check mark in "Internet
Time Server" to obtain the correct time. Then enter the IP
address or host name of the NTP server to perform updat-
ing.
Summer time set-
Set summer time. When Enable is checked, summer time
ting
is enabled. Set the various time differences and the start
and end of summer time.
Important:
• When using the clock function of this device, leave the device in the standby mode if it is not going to be used.
If the projector leaves for over two weeks without the power supply, the set date and time will be reset to the factory default setting
and the clock function will become ineffective. When the clock function becomes ineffective, set "Date and time" again.
NOTE:
• If date and time is reset around the timing of starting or finishing Summer time, Summer time setting may not become effective
properly.
In case date and time is required to reset, perform the settings in order of TIME ZONE → DATE AND TIME SETTING → SUMMER
TIME.
8-4. ADMINISTRATOR MODE
Select the menu mode of this device, enable/disable the saving of settings of the entire projector, and configure thep-
assword setting in the administrator mode.
Item
Description
Menu mode
Select the basic menu or advanced menu. See the user's
manual of the projector for the items that can be used in the
respective menus.
Do not save the set-
Put a check mark if you are not saving the value of the con-
tings
figured item in the on-screen menu.
New password / Con-
Set the password in the administrator mode.
firm new password
8-5. DEFAULT APP
Omit to display the application menu and select the start-up function either when the APPS button on the remote
control is pressed, or [APPS] is selected as the input terminal on the onscreen menu.
Item
Description
Default application
When the projector is turned on under the condition of being
selected the "APPS" terminal, select function either the APPS
MENU or the viewer.
35
8. TOOLS
Remarks
The default value is "+00:00".
Example: When using the
device in Japan, set it to
"+09:00".
The default date is
"01/01/2015" (Thu). The de-
fault time is "00:00".
Remarks
No check mark as the factory
default setting.
A maximum of 10 alphanumeric
characters.
Remarks
The default factory setting is
"APPS MENU".
Advertisement
Table of Contents
