NEC NP-CR5450HL User Manual page 26

Advanced Settings (Profile 1 / Profile 2)
Item Description
Site survey • Run the site survey and display the detected access
• A maximum of 64 access points can be displayed.
• Only 1 access point with the same name as SSID is dis-
• The applicable access points are the security-disabled
• A "Key" mark is attached when the security setting of the
Security setting Select the type of security.
• Disable: Disable the security setting.
• WPA2-PSK: Input column of the key is displayed.
• WPA/WPA2-PSK: Input column of the key is displayed.
• WPA2-EAP: Authentication settings are displayed.
• WPA/WPA2-EAP: Authentication settings items are dis-
SSID Set the SSID.
[AUTHENTICATION]
Setting is required for using WPA2-EAP or WPA/WPA2-EAP.
Preparation before setting
Select a wireless LAN compliant WPA-EAP or WPA2-EAP authentication and install a digital certificate on the projec-
tor.
1. Set [DATE AND TIME] and [TIME ZONE] on the projector. (→ page 35)
2. Use a computer to save digital certificates (files) for WPA2-EAP setting to your USB memory device.
After completing saving the file, remove the USB memory device from the computer.
Important:
• The supported file extensions for client certificate are ".pfx" and ".p12", for root certificate are ".cer" and ".der".
• The file formats of digital certificate that are supported by the projector are DER and PKCS#12 only.
• The projector cannot handle any digital certificate whose file size exceeds 8 KB.
3. Plug the USB memory device into the USB port of the projector.
Setting Procedures
1. Select either [WPA2-EAP] or [WPA/WPA2-EAP] for the [SECURITY TYPE] on the [SECURITY] page
The pull-down list will be displayed.
2. Focus on the [AUTHENTICATION].
Select either [EAP-TLS] or [PEAP-MSCHAPV2] for [EAP TYPE]. The setting items vary depending on the EAP
type.
points.
played.
WPA-PSK, WPA2- PSK, WPA-EAP and WPA2-EAP.
access point has been enabled.
played
26
7. NETWORK SETTINGS
Remarks
Selection is not possible if this
device is not connected to a
wireless LAN unit.
NOTE: If any access point is not
searched, select the site survey
again after selecting [RECONNECT]
on the wireless LAN screen.
• The default factory setting
when shipped is "Disable".
This consists of 1 - 32 half-byte
alphanumeric characters.
The default factory setting when
shipped is "NECPJ".