Table of Contents
Advertisement
This guideline is intended for users to ensure safe installation, operation, and maintenance of J & E Hall Cellar Plus Cellar
Coolers. This guideline is not intended to replace the system expertise available from the system manufacturers.
This equipment is a relatively complicated apparatus. During installation, operation, maintenance or service, individuals may be
exposed to certain components or conditions including, but not limited to refrigerants, materials under pressure, rotating
components, and both high and low voltage. Each of these items has the potential, if misused or handled improperly, to cause
bodily injury or death. It is the obligation and responsibility of operating/service personnel to identify and recognize these
inherent hazards, protect themselves, and proceed safely in completing their tasks. Failure to comply with any of these
requirements could result in serious damage to the equipment and the property in which it is situated, as well as severe personal
injury or death to themselves and people at the site.
This document is intended for use by owner-authorized operating/service personnel. It is expected that these individuals possess
independent training that will enable them to perform their assigned tasks properly and safely. It is essential that, prior to
performing any task on this equipment, this individual shall have read and understood this document and any referenced mate-
rials. This individual shall also be familiar with and comply with all applicable governmental standards and regulations
pertaining to the task in question.
SAFETY SYMBOLS
The following symbols are used in this document to alert the reader to specific situations:
Warning! Risk of serious injury or
death to person!
WARNING
Caution! Danger which can lead to
serious damages!
CAUTION
Notice! Risk of damage to equipment!
NOTICE
NOTICE
Disposal requirement
Your refrigeration product is marked with this symbol. This means that electrical and electronic products shall not be
mixed with unsorted household waste. Do not try to dismantle the system yourself: the dismantling of the refrigeration
system, treatment of the refrigerant, of oil and of other parts must be done by a qualified installer in accordance
with relevant local and national legislation. Refrigeration equipment must be treated at a specialized treatment
facility for re-use, recycling, and recovery. By ensuring this product is disposed of correctly, you will help to prevent
potential negative consequences for the environment and human health. Please contact J & E Hall for more information.
Issue: 01.06.2023
IMPORTANT!
READ BEFORE PROCEED!
GENERAL SAFETY GUIDELINES
Page II
Advertisement
Table of Contents
