3Com Router 3000 Series Manual page 4

1.1. V1.20 Release Notes
This chapter offers updates on Router 3000 and Router 5000 features in the following
areas:
System Access
SNMP
System Management
Interface Management
Link Layer Protocol
1.1.1. System Access
Symptom
The following commands will not be available
after an upgrade from V1.10:
undo login pad
terminal telnet refuse-negotiation
terminal telnet break-on-ip
1.1.2. SNMP
Symptom
Routers are not recognized by Network
Management applications, such as 3Com
Network Supervisor, unless SNMP V1 is
enabled.
Adding a row to the RMON2 trapDest table
does not automatically enable traps.
In the RMON2 trapDest table, the RowStatus
value of CreateAndGo(4) is not correctly
implemented.
SNMPv3 traps are not being generated.
3Com Router Release Notes for V1.20
Network Protocol
Routing Protocol
Multicast Protocol
Security
VPN
Those commands are now undo login-
method authentication-mode pad, reverse-
telnet no-negotiation, and reverse-telnet
break-on-ip, respectively
Enable SNMP V1 on the device, as described
in the Installation Guide, then discover the
network using 3Com Network Supervisor.
Use the snmp-agent trap enable command.
Use CreateAndWait(5) and set the row Valid(1)
using a second PDU.
SNMPv3 traps are not supported in this
release.
4
QoS
Dial-Up
Documentation
Resolved Issues
Solution
Solution