Advertisement
Quick Links
53800 / 01
Please determine your function type prior to installation.
Passage
(Hall/ Closet)
*Tools
*Tools will depend on install type
Scroll to the bottom if you need help in preparing your door
1
Adjust the backset of the latch (if needed)
A
Hold the latch in front of the door hole, with
the latch face ush against the door edge.
B
If the latch holes are centered in the door hole,
no adjustment is required. Proceed to step 2.
If the latch holes are NOT centered, adjust
latch. See "Latch Adjustment" (step 2C).
C
Latch Adjustment (only if needed)
Move the pin to
extend the latch.
2
Install latch
Door edge chiseled
3
Install levers (concealed screws)
A
Push bolt to install
exterior lever.
D
interior
This manual can be used to install a variety of levers.
Privacy
(Bed/ Bath)
slant of latch bolt
faces door frame
door frame
interior
E
Entry
(Keyed)
or
Remove plates
Install drive-in collar
Use hammer
and wood
block to tap in
latch without
damaging it.
B
interior
Installation Guide
1-800-327-5625
www.kwikset.com
Dummy
(Non-Rotating)
wood block
Door edge NOT
chiseled
slant of latch bolt
faces door frame
wood block
C
Keep turn button
horizontal as shown.
interior
F
centered
not centered
door frame
interior
Advertisement
Related Manuals for Kwikset Henley 300HYL 15
Summary of Contents for Kwikset Henley 300HYL 15
- Page 1 Installation Guide 1-800-327-5625 www.kwikset.com 53800 / 01 This manual can be used to install a variety of levers. Please determine your function type prior to installation. Passage Privacy Entry Dummy (Hall/ Closet) (Bed/ Bath) (Keyed) (Non-Rotating) *Tools wood block *Tools will depend on install type...
- Page 2 Install levers (exposed screws) Option 1: Install privacy/passage levers Lever handle faces Press latch bolt away from latch. to install lever. IMPORTANT: If installing a passage lock on an entry door, make sure the lever without the screw holes Hole must be on the side exterior is on the exterior side of the door.
- Page 3 2-3/8 in (60mm) 1 in 2-3/4 in (70 mm) 25 mm 2-1/8 in *Call Kwikset to order a 54 mm service kit for 2-1/4 in (57 mm) thick doors. Use template to mark holes on door Select the template that allows you to place the template on the EXTERIOR side of door.
- Page 4 3/32" 3/32" 2 mm 2 mm Register your product at www.kwikset.com/productregistration Rate your product at www.kwikset.com/reviews 3/32" WARNING: This Manufacturer advises that no lock can provide complete security by itself. This lock may be defeated by forcible or technical means, or evaded by entry elsewhere on the property. No lock 2 mm can substitute for caution, awareness of your environment, and common sense.