Care Recommendations - Wolf ICBCG304T/S Use And Care Manual

Cooktop Operation
Cooktop Operation
SURFACE BURNERS
To light a burner, push and turn the corresponding con-
trol knob counterclockwise to . The igniter will
begin to click until burner is lit. Once lit, continue to turn
knob counterclockwise to desired setting. Each burner is
designed with electronic re-ignition which reignites the
burner if accidentally extinguished.
To select a simmer setting, turn control knob to the detent
at the lowest setting. Push and continue to turn counter-
clockwise. The flame will transition to the second tier on
the burner cap. Continue to turn knob to desired simmer
setting.
SURFACE BURNER RATING
The front left burner is 5.3 kW. The rear center burner is
3.5 kW (rear right for model ICBCG304). Any additional
burners are 2.7 kW.
CAUTION
Never leave pans on a high setting unattended. Be
careful when cooking food in fat or grease; it can
become hot enough to ignite.
WARNING
Turn off the burner if clicking is not audible within
five seconds. Do not operate and contact Wolf
Factory Certified Service.
8 | English
CAUTION
Do not use pans smaller than 120 mm in diameter.
Do not use pans that extend beyond the cooktop
frame. Heat may be trapped beneath the pan causing
damage.
CONTROL KNOBS
For 381 mm and 914 mm models, the control knobs are
positioned to correspond with the surface burners they
regulate. For 762 mm models, a diagram above each knob
indicates which surface burner it regulates.
BURNER GRATES
For 610 mm models, the grates must be positioned cor-
rectly to ensure proper burner performance. The grates
have an indicator on the bottom of the front edge. Position
the grates with the indicator toward the front of the cook-
top. Refer to the illustration below.
FRONT
Grate placement (610 mm model)

Care Recommendations

Care Recommendations
CLEANING
Stainless steel Use a nonabrasive stainless steel cleaner and apply with a soft lint-free cloth. To bring out the natural luster,
lightly wipe surface with a water-dampened microfiber cloth followed by a dry polishing chamois. Always
follow the grain of stainless steel.
Burner grates
Remove and place on a flat surface near the sink. Clean with hot water and mild detergent or paste of baking
soda and water. Do not immerse in water. Towel dry.
Surface burners Allow to cool. Use mild detergent or spray degreaser to clean. Rinse with water and towel dry.
Control knobs Using a damp cloth, wipe with mild detergent or spray degreaser; rinse and dry. Do not place in dishwasher.