Getting Started - VTech CAR-BOARD RACERS OFF-ROADER & TRACK Instruction Manual

GETTING STARTED

Battery Removal and Installation
1. Make sure the vehicle is turned Off.
2. Find the battery cover located on the
wheels on each side, use a screwdriver
to loosen the screw and then open the
battery cover.
3. Remove the old battery by pulling up on
one end of the battery.
4. Install 1 new AA (LR6/AM-3) battery
in each battery box following the
diagram inside. (For best performance,
alkaline batteries or fully charged
Ni-MH rechargeable batteries are
recommended.)
5. Replace the battery cover and tighten
the screw to secure.
6. Do the same installation on the other
side of the vehicle.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
5