Battery Removal And Installation - VTech CAR-BOARD RACERS STARTER SET Instruction Manual

BATTERY REMOVAL AND INSTALLATION

1. Make sure the unit is turned Off.
2. Find the battery cover located on the
wheels on each side, use a screwdriver
to loosen the screw and then open the
battery cover.
3. Remove the old battery by pulling up on
one end of the battery.
4. Install 1 new AA (LR6/AM-3) battery
following the diagram inside the
battery box. (For best performance,
alkaline batteries or fully charged
Ni-MH rechargeable batteries are
recommended.)
5. Replace the battery cover and tighten
the screw to secure.
6. Do the same installation on the other
side of the vehicle.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
5