Table of Contents
Advertisement
10 If using the nut plates, starting in one corner of the template, place a
nut plate
over the hole
The other hole
on the nut plate should line up with the inner hole on
the template.
11 If the other hole on the nut plate does not line up with the inner hole on
the template, mark the new location.
12 Repeat for each nut plate.
9
13 Using a 3.5 mm (
/
in.) drill bit, drill the inner holes.
64
14 Remove the template from the mounting surface.
15 Starting in one corner of the mounting location, place a nut plate
lining up the inner and outer holes.
The raised portion (the collar) of the nut plate should fit into the outer hole.
16 Secure the nut plate to the mounting surface by fastening an included M3 pan-head screw
9
inner 3.5 mm (
/
in.) hole.
64
17 Repeat for each nut plate.
18 If you will not have access to the back of the device after you mount it, connect all necessary cables to the
device and install a memory card before placing the device into the cutout.
19 Place the device
into the cutout.
20 Secure the device to the mounting surface using the included M3 flat-head screws or wood screws
depending on the mounting method.
21 Snap the bezel
into place.
4
drilled in the previous step.
on the back of the mounting surface,
through the
,
Advertisement
Table of Contents
