Table of Contents
Advertisement
NZ AU
7.10 Start wash programme
and lights up continuously.
Appliance operates according to present settings.
Changes are only possible by cancelling the programme.
7.11 Interrupt / cancel wash programme
To interrupt a running programme press gently "Start/Pause". The LED above the button
is ashing. Press it again to resume operation.
To cancel a running programme and all its individual settings:
1. Press "Start/Pause" button to interrupt the running programme.
2. Touch "Power" button for about 2 seconds to switch the appliance off.
3.
Touch "Power" button to turn on the appliance. No select speed and run programme
Spin to drain water.
4. After select a new programme and
7.12 After washing
Note: Door lock
For safety reasons the door is locked partially during the washing cycle.It is only
possible to open the door at the end of the programme or after the programme
was cancelled correctly(see description above).
In case of high water level,high water temperature and during spinning it is not
possible to open the door;
1. At programme cycle end
2.
3. Remove laundry as soon as possible to go easy on it and to prevent more wrinkling.
4.
5. Unplug the power cord.
6. Open the door to prevent formation of moisture and odours. Let it open while not used.
Note: Standby-mode / energy -saving mode
The switched on appliance will go into standby-mode if it will not be activated within 2
minutes before starting the programme or at the end of programme. The display
switches o . This save energy.
7.13 Activate or deactivate the buzzer
The acoustic signal can be deselected if necessary:
1. Switch on the appliance.
. 3
Press the "Smart Dose" button and "Dry Level" button at the same time for
about 3 seconds. " " will be displayed and the buzzer will be deactivated.
For activating the buzzer p ress these three buttons at the same time again. "
will be displayed.
7-8
start it.
is displayed.
is displayed.
2. Select ''Express 15'' programme
7-Daily use
ashing
7-8
"
21
Advertisement
Table of Contents
