Table of Contents
Advertisement
Service
Replacing Parts in the Oscilloscope
To remove the handle
•
Rotate the handle down until it is just past the last detent position
(about 1/2 inch before the handle touches the bottom of the
oscilloscope), then pull the sides of the handle out of the cabinet.
To order a replacement part
The system board is part of an exchange program with Agilent Technologies.
The exchange program allows you to exchange a faulty assembly with one
that has been repaired and performance verified by Agilent Technologies.
After you receive the exchange assembly, return the defective assembly to
Agilent Technologies. A United States customer has 30 days to return the
defective assembly. If you do not return the faulty assembly within the 30
days, Agilent Technologies will charge you an additional amount. This
amount is the difference in price between a new assembly and that of the
exchange assembly. For orders not originating in the United States, contact
your nearest Agilent Technologies Sales Office for information.
3-45
Advertisement
Table of Contents
