How To Configure The Remote Control; Swi-600 And The Wall Switch Swi-610/ Swi-620 - Steren SWI-600 Instruction Manual

How to configure the remote control

SWI-600 and the wall switch SWI-610/ SWI-620

Make sure that the wall switch is correctly installed to electrical current system.
1.- Release the top cover from the wall switch (Fig. 2). Release the on / off button (Fig. 3),
too.
2.- Press on/off switch (1), the lamp will light on.
3.- Press Learning button (3) with a pointed object. The indicating LED (2) starts to blink.
4.- Aim the remote control to the wall switch.
5.- Press the button which you want to control the wall switch (A, B, C or D) (4) once. The
indicating LED (2) blinks once again and then turn off after a second.
6.- Press the programmed button (4), the lamp will turn off and turn on.
12