Filling Water Tank - Sharper Image THREAD EXPRESS Owner's Manual

FILLING WATER TANK

1. Turn OFF ( ) and unplug unit from power source.
CAUTION: If unit has been in use, allow to cool (5 minutes for minimum cooling
before removing Water Tank and adding water).
2. Remove Water Tank by twisting to the unlock position and pulling
Water Tank away from the unit, see Figure 1.
3. Remove rubber cap from top of Water Tank and fill with distilled water
from a bottle or cup. Replace rubber cap on top of the Water Tank. Do
not overfill Water Tank.
NOTE: In order to extend the life of your unit and keep it functioning
at it's maximum potential, it is highly recommended that distilled or
demineralized water be used in Water Tank.
4. Replace Water Tank by pushing firmly into the unit and twist tank to
lock position until it clicks into place.
WARNING - Take care to not pinch your fingers or hand when
replacing water tank into unit.
English 11