Maintenance - Profi-pumpe 3-STUFIGE STEINKASKADE Operating Instructions Manual

Problem: Uneven water distribution or water splashes in the well area.
Correction: During the initial start-up, the water distribution may be uneven. In such cases we
recommend checking and adjust the accuracy of the fountain and the water flow (see page 18).

9. MAINTENANCE:

z Keep the fountain in good working condition by cleaning it and changing the water every
3 days. Using distilled or purified water will give the best performance.
z If debris is caught in the intake vents of the pump, disconnect the pump from any power
sources and rinse the pump under clean running water.
z Before storing the pump in winter it is absolutely important to rinse it with clean water.
z Any dirt particles remaining in the pump will dry out on the the pump shaft during the time of storage
and cause irreparable damage.
If after some time the pump starts losing power or stops working, please clean up sediment
in the pump shell or filter cribs. Kindly note the pump can be opened by pressing down at
the bottom of the filter housing. To clear the impeller, open the pump housing at the front by
sliding up the front plastic cover.
VERSION 1
The solar module should only be cleaned with
soft tissue or propriety glass cleaning solution.
VERSION 2
The solar module should only be cleaned with
soft tissue or propriety glass cleaning solution.
IMPORTANT!
Pull off filter cover as shown
Open impeller cover, then im-
peller can be easily removed
Pull off filter cover as shown - remove filter and pump motor.
English 7
Remove fitter and rinse in water
Rinse all parts thoroughly in water