Table of Contents
Advertisement
Figure 61
1. Wood block—6.6 cm
(2-5/8 inches) thick
6.
Remove the hairpin cotter and washer from the
lower lift-arm pin
(Figure
Figure 62
1. Height-of-cut plate
2. Hairpin cotter
7.
Rotate the height-of-cut plate to a different hole
so that it supports the weight of the mower deck
after you install the plate
g294196
2. Wood block—7.3 cm
(2-7/8 inches) thick
62).
g294197
3. Washer
(Figure
63).
8.
Install the washer and hairpin cotter
9.
Repeat steps
the machine.
10.
Check the side-to-side level again; repeat this
procedure until the measurements are correct.
11.
Continue leveling the mower deck by checking
the front-to-rear blade slope; refer to
the Front-to-Rear Blade Slope (page
Adjusting the Front-to-Rear Blade
Slope
1.
Rotate the adjustment nut in the front of the
mower
(Figure
1. Adjusting rod
2. Adjusting block
2.
To raise the front of the mower deck, tighten the
adjustment nut.
45
Figure 63
(Figure
6
through
8
for the other side of
64).
Figure 64
3. Adjustment nut
g294195
63).
Checking
44).
g294471
Advertisement
Table of Contents
