Advertisement
RF-24E
Wireless Remote Control
For Cub series ATV/UTV Winch
Wireless Control Kit includes:
1 Wireless Receiver.881103
2 Wiring Harness 1250 mm.
3 Wireless Transmitter.881102
4 Transmitter Holder.881861
5 Lithium Battery: 3V CR2032
6 Handsaver Strap.
I.Specifications
1. Transmission range: 15 ~ 27 m (50 ~ 90 ft)
2. Receiver operation voltage: 8 ~ 24 V
3. Receiver fuse current rating: 7.5A
4. Protection: IP-66
5. Operating temperature range: -20°C ~ +70°C
II.Installation Guide
Step 1: Connect the wiring
a. Connect the Black and Green wires to the same color wires on the contactor and
handlebar trigger switch respectively shown on the wiring diagram.
b. Slice the Red wire to the receiver fuse then connect to the positive (+) terminal of the
battery.
c. Connect the Black wire to the negative (-) terminal of the battery.
Step 2: Mount the Receiver
a. The receiver should be mounted in a clear and dry location.
b. Mount on a flat surface with 2 pcs of Ø7 mm mounting
holes on each side of the receiver.
INSTALLATION GUIDE
1.
3.
2.
4.
Minimum of one mounting hole each side
1
Part No.881776
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Comeup RF-24E
Summary of Contents for Comeup RF-24E
- Page 1 INSTALLATION GUIDE Part No.881776 RF-24E Wireless Remote Control For Cub series ATV/UTV Winch Wireless Control Kit includes: 1 Wireless Receiver.881103 2 Wiring Harness 1250 mm. 3 Wireless Transmitter.881102 4 Transmitter Holder.881861 5 Lithium Battery: 3V CR2032 6 Handsaver Strap. I.Specifications 1.
- Page 2 III Operation 1. Install and replace battery. a. Remove the three screws from the wireless transmitter. b. Separate the top section and remove the old battery and dispose it. c. Insert new battery and join the top section with the bottom section. d.
Need help?
Do you have a question about the RF-24E and is the answer not in the manual?
Questions and answers