Maintenance; Environmental Protection - KRESS KU320 Manual

1. ON/OFF SWITCH WITH VARIABLE SPEED
CONTROL
Depress to start and release to stop your tool. This
tool has a variable speed switch (1) that delivers
higher speeds with increased trigger pressure - speed
is controlled by varying the pressure applied to the
switch. (See Fig. A)
2. SWITCH LOCK-ON BUTTON
Depress the on/off switch (1) then the lock on button
(2) (See Fig. A) release the on/off switch first and the
lock-on button second. Your switch is now locked on
for continuous use. To switch off your tool just depress
and release the on/off switch.
3. AUXILIARY HANDLE
Slide the handle onto the drill and rotate to the desired
working position. To clamp the auxiliary handle rotates
the handle clockwise. To loosen the auxiliary handle,
rotate the handle anti-clockwise. (See Fig. B)
Warning: Always use the auxiliary handle.
4. FORWARD AND REVERSE ROTATION
CONTROL
With the drill pointing away from you, push the forward/
reverse-lever (3) to the left "
Push the forward/reverse-lever (3) to the right for
reverse rotation " ".
WARNING: Never change the direction of
rotation while the tool is rotating, wait until it has
stopped.
5. ADJUSTABLE DEPTH GAUGE
Fit the drill bit into the chuck. Loosen the depth stop
by rotating the handle anti-clockwise. Slide the depth
gauge until the distance between the depth gauge end
and the drill bit end is equal to the depth of hole/screw
you wish to make. Then clamp the depth gauge by
rotating the handle clockwise.
6. FUNCTION MODE SELECTION (See Fig. C)
The operation of the gearbox for each application is set
with the function mode selection switch (4), To change
between functions, depress the release button (9) and
rotate the selector to the desired operating mode.
Function
For simultaneous
drilling and impacting
of concrete or masonry,
choose the Hammer
drilling position.
For drilling into steel,
wood and plastics
choose the Rotary
drilling position.
For impacting only
- for light chipping,
chiseling and demolition
applications choose the
Hammer position.
" for forward rotation.
For adjustment of
the chiseling position
choose the bit angle
position
WARNING: The operating mode selector switch
may be actuated only at a standstill.
WARNING: Prolonged use will cause the
aluminum housing to become hot, do not touch.

MAINTENANCE

Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in
your power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls
free of dust.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
ENVIRONMENTAL
PROTECTION
Disposal
The machine, its accessories and packaging
materials should be sorted for environmentally
friendly recycling. The plastic components are labeled
for categorized recycling.
7
EN