Table of Contents
Advertisement
Quick Links
Installation and operating instructions
Setup
This manual describes the most essential
functions and technical specifications of the
thermostat. These instructions help the user to
Control the thermostat, and the electrician to
install and setup the thermostat.
Technical specifications
Display: 1.8" TFT, 128x160 resolution
Power supply: 230V - 50/60 Hz
Maximum load: 16A (resistive)
Setpoint temperature range: +5 °C/+40 °C
Usage temperature range: 0 °C/+40 °C
Temperature setback: Pilot wire 230V - 50/60 Hz
IP class: IP21
Standard Color: White RAL9003
Sensors: Built-in room sensor and floor sensor
NTC 10kΩ included
Wi-Fi: 2.4GHz 802.11bgn (TPT16WF)
Approvals: EN 60730-1, EN 60730-2-9,
EN 300 328 V2.2.2
Installation
Installation must be done by a qualified
electrician in accordance with wiring and
building regulations.
Before installation, disconnect any power to the
thermostat's mains. During installation of the
thermostat, power to the thermostat must be
disconnected or isolated AT ALL TIMES!
TPT16 / TPT16WF
Release the front cover by pressing with
screwdriver from the ejector latch at the
bottom of the thermostat. Open the spring and
remove the frame.
Wires must be stripped 9-10 mm. Wires can be
released by pressing the connector's release
pin. Floor sensor must be placed into protective
tube in concrete. Make sure there is no water in
the tube.
Now connect the wires to the thermostat's
terminals:
PILOT:
LOAD (N):
N:
L:
LOAD (L):
SENSOR:
Next, position the thermostat and fasten it onto
the wall's mounting box using 2-4 screws. Open
the frame retaining spring, position the frame
and close the spring. Then attach front part,
make sure the connector between front and
bottom part is correctly placed. Press front part
until it snaps in place. Front part can later be
removed by pressing the ejector latch.
Pilot Wire (if applicable)
Heating Cable connection (Neutral)
Power connection (Neutral)
Power connection (Live)
Heating Cable connection (Live)
Floor temp sensor NTC type
EN
1
Advertisement
Table of Contents
Related Manuals for Frico TPT16
Summary of Contents for Frico TPT16
- Page 1 TPT16 / TPT16WF Installation and operating instructions Release the front cover by pressing with screwdriver from the ejector latch at the bottom of the thermostat. Open the spring and remove the frame. Wires must be stripped 9-10 mm. Wires can be released by pressing the connector’s release...
- Page 2 Control reset, a start-up wizard will prompt the The thermostat is controlled directly or following questions: via App Frico TPT (TPT16WF), see "Wi-fi Language Set language settings (TPT16WF)" and "Phone applications (TPT16WF)"...
- Page 3 TPT16 / TPT16WF Anti-frost Menu items This mode drops setpoint to 7 °C. It Operation mode See "Operation Mode" can be used e.g. in summer cottage during winter time. Schedule See "Schedule" Settings Adjust settings Power regulation Wi-Fi Adjust Wi-Fi settings...
- Page 4 Heating Setup Change heating or Reconfigure Wi-Fi menu. cooling setup Phone applications (TPT16WF) NTC sensor Change NTC type Download ”Frico TPT” from App store or Google Hysteresis Change temp Play. variation Calibration Fine tune temp Packaging...
Need help?
Do you have a question about the TPT16 and is the answer not in the manual?
Questions and answers