Table of Contents
Advertisement
NOTE:
Typically, the irf auto-update enable command can automatically synchronize a member
device with the software version of the master device. However, the synchronization might fail
when the gap between the software versions is too large. For more information, see the release
notes.
8.
If the issue persists, contact H3C Support.
Related commands
This section lists the commands that you might use for troubleshooting IRF.
Command
display interface
display irf
display irf configuration
display irf topology
display version
irf-port-configuration
active
undo shutdown
Description
Displays interface information.
Use this command to verify that each IRF port has a minimum of one
physical interface in up state.
Displays IRF fabric information, including the member ID, role, priority,
bridge MAC address, and description of each IRF member.
Displays basic IRF settings, including the current member ID, new
member ID, and physical interfaces bound to the IRF ports on each IRF
member device. The new member IDs take effect at reboot.
Displays the IRF fabric topology, including the member IDs, IRF port
state, and adjacencies of IRF ports.
Displays system version information.
Activates IRF configuration on IRF ports.
Brings up an Ethernet interface or subinterface.
19
Advertisement
Table of Contents
Troubleshooting
