Electrolux ST281F User Manual page 73

3.4 Rear spacers
In the bag with the documentation, there are
two spacers which must be fitted as shown in
the figure.
If you position the appliance against a wall in
a freestanding installation, install the rear
spacers in order to guarantee the maximum
possible distance.
3.5 Door reversibility
WARNING!
Before carrying out any operations,
remove the plug from the power socket.
Empty the appliance.
1. Make sure the appliance stands upright.
2. Open both doors and remove the door
equipment. Refer to the "Daily use"
chapter. Close the doors.
3. Use a thin-blade screwdriver to remove
the screw hole cover (A) and the upper
hinge cover (B). Put them aside.
A B
4. Unscrew the screws of the right upper
hinge. Support the upper door with your
hand. Remove the upper hinge, reverse
it, screw the screws and the pin to it. Put
the hinge aside.
1
5. Carefully lift the upper door from the
middle hinge to remove it. Place the
upper door on the soft surface. Be careful
not to lose washers that may stick to the
door.
6. Unscrew the screw (B) and the "stop
block" (A) and screw them on the
opposite side of the door.
A
B
7. Unscrew the screws from the middle
hinge. Remove the middle hinge and put
it aside together with the screws.
Be careful not to lose washers that may stick
to the door.
2
3
1
3
2
ENGLISH 73