4K5 WL 380 Manual page 7

! Completely read through the operating instructions as well as the latest
information under the internet link at the end of these instructions. Follow
the instructions they contain. This document must be kept in a safe place
and passed on together with the device.
Intended use
The product is intended for illuminating work areas. The work lamp has a floodlight
with three light levels and a spotlight with two light levels. To change the operating
mode between flood light and spot light, the operating button must be held down for
about one second. The light head can be swivelled by 180°. The suspension bracket
is equipped with magnets for attaching to metal surfaces. The USB-C interface is
available for charging the device.
General safety instructions
– The device must only be used in accordance with its intended purpose and within
the scope of the specifications.
– The appliance and its accessories are not toys for children.
– Modifications or changes to the device are not permitted, this will otherwise
invalidate the approval and safety specifications.
– Handle discharged batteries with care. Battery packs are a source of danger
as they can cause very high short-circuit currents. Even if Li-Ion battery packs
appear to be in a discharged state, they never discharge completely.
– Avoid physical impacts.
– Impacts, force and penetration of objects can damage the batteries. This can lead
to leakage, heat and smoke generation, ignition or explosion.
– A short circuit between the battery pack electrodes may result in burns or fire.
– Protect the battery pack from heat as well as permanent sunlight and fire, e.g. do
not leave it in the car in summer, as this can cause explosions.
– Charge the battery pack at ambient temperatures between -10°C and 40°C.
– Do not expose the device to mechanical stress, extreme temperatures, moisture
or significant vibration.
– The optimum charge level is between 50 % and 80 %.
– Use the mains/charger unit only inside closed rooms, do not expose to moisture
or rain, otherwise there is a risk of electric shock.
– Fully charge the battery before using the unit.
– Charging is complete when the power indicator flashes.
– If the battery is weakly charged, the power indicator flashes.
– The battery can also be charged during operation.
– After charging, remove the charging cable and disconnect the power supply unit
from the mains.
WL 380
07
EN