Honda CRF50F 2009 Owner's Manual page 103

RIGHT REAR
(10)
(8) lug
(9) slot
(10) brake panel
Installation
1. Reverse the removal procedure. Make sure
the lug ( ) on the swingarm is located in the
slot ( ) in the brake panel ( ). Check that
the chain adjusters are installed properly.
2. Adjust the drive chain (page
3. Torque the rear axle nut to:
35 lbf·ft (46 N·m , 4.8 kgf·m)
(8)
4. Adjust the rear brake (page
5. Apply the rear brake, release it, then spin the
wheel and check that it rotates freely. Repeat
this procedure several times.
(9)
If a torque wrench was not used to install the
wheel, see your Honda dealer as soon as
possible to verify proper assembly. Improper
assembly may lead to loss of braking capacity.
8
9
Servicing Your Honda
Wheels
10
103 ).
88 ).
95