KitchenAid 860-0003 Installation Instructions And Use & Care Manual page 23

7. Test all connections using an approved noncorrosive
leak-detection solution. Bubbles will show a leak. Correct
any leak found.
Change the Side Burner orifice
1. Remove the screw securing the igniter and the 2 side 1 R th
burner screws.
2. Lift out the side burner.
3. Locate the Liquid propone orifice at the end of the valve
and use a 6 mm socket and wrench or 6 mm nut driver to
remove. The side burner NG orifice is located
behind the LP orifice, so no additional orifice needs to be
installed.
i th i it d th 2 id
A. Orifice
4. Reinstall the side burner. Make sure that the
igniter is out of the way to allow proper positioning of
burner. Use Phillips screwdriver to attach the mounting
screws.
5. Use Phillips screwdriver to reattach the igniter and
searing side burner plate.
6. Open the manual shutoff valve in the gas supply
line. The valve is open when the handle is parallel to the
gas pipe.
IMPORTANT: Open the right door. Check that the orifice is
properly installed inside of the burner venturi from right side
door by using a flashlight.
A.
23