Bissell DIGIPRO 2142 Series User Manual page 9

Manual Cleanings Using Control Panel
Selecting a
Cleaning Time
1st Press
2nd Press
3rd Press
4th Press
5th Press
6th Press
7th Press
8th Press
Selecting the
Navigation
1st Press
2nd Press
3rd Press
4th Press
5th Press
Selecting the
Cleaning Power
1st Press
2nd Press
Display on screen
Control Panel Display
Control Panel Display
Control Panel Display
What It Does
Battery Low: Battery needs to be charged
(Power LED turns Red)
The trash can indicator shows the dust bin is full and needs to be
emptied
What It Does
Maximum run time - will return to the
docking station to recharge
30 minute run time - will return to the
docking station to charge
45 minute run time - will return to the
docking station to charge
60 minute run time - will return to the
docking station to charge
Sends robot back to the docking station
without cleaning
30 minute run time - will not return to the
docking station
45 minute run time - will not return to the
docking station
60 minute run time - will not return to the
docking station
What It Does
Spiral - Robot will work in circles until it
encounters an obstacle (once it encounters
an obstacle it will switch to AUTO mode)
Along the Wall - Robot will clean along
walls and edges
"Z" Formation - Robot will move up and
down the room following a zig-zag path
Diagonal Path - Robot will move in diagonal
paths around the room, adjusting its
direction as obstacles are encountered
Auto - Robot will cycle through all modes
(Spiral, Along the Wall, "Z" Formation, and
Diagonal Path)
What It Does
Cleaning power is set to Normal
Cleaning power is set to Turbo
www.BISSELL.com
9