Berrcom JXB-182 Instruction Manual page 5

fans) .
. Do NOT take an individual's temperature shortly after he or she participated in
vigorous physical activity, bathed, took medicine, ate or drank, or had a cold or warm
compress on his or her forehead.
. Do NOT take an individual's temperature when there has been a significant change in
ambient conditions. Allow the device to adjust to the significant change in the ambient
temperature due to a change in environment for at least 30 minutes before taking the
measurement.
. Wait at least 3 to 5 seconds between measurements.
. We recommend that you take three measurements on the forehead. If the results of
the three measurements are different, use the one with the highest value.
VI. TURNING ON AND SETTING THE THERMOMETER
1. Turning on the device
Press the On/Scan button. The display will illuminate, and enter the standby mode and will
display "---°C" or "----°F". Next, place the device 3-5 cm (1.2-2in) away from the individual's
forehead, aim the sensor of the device toward the forehead, and press the On/Scan button
again, which will then take the individual's temperature.
The device will automatically shut off after 30 seconds of non-use.
2. Setting the MODE when the device is on
a. Press "MODE" button, if the screen display: Body...°C, it is "Body temperature mode".
b. Press "MODE" button again, if the screen display: Surface Temp...°C
temperature mode".
c. Press "MODE" button again, if the screen display: Room...°C
mode".
Note: The thermometer default is set to BODY temperature mode.
NOTE
THE SURFACE TEMPERATURE AND ROOM TEMPERATURE ARE NOT MEDICAL USE.
The surface temperature differs from the body temperature. To obtain the body temperature,
you should use the "body temperature mode".
Use the Surface Temperature Mode to measure the temperature of a baby-bottle/bath water
and the Room Temperature Mode to measure the room temperature.
3. Choosing the temperature unit
When the device is on, press "MODE" button for 2 seconds, the screen will display "F1", then
press "MODE" button to transfer between degree Celsius and Fahrenheit, by pressing "MEM"
button to confirm.
4. View previous measurement results
In the switch on state, press "MEM" button, which will then display the last temperature and
allow for a view of the last 32 measurements.
5
it is "Surface
,
it is "Room temperature
,