Disabling A Forgotten Password - Dell EMC NX430 System Owner's Manual

Table of Contents

Advertisement

Item
Connector
15
SYS_PWR
16
SATA0-3
17
FAN4
18
PWRD_EN
19
FAN3
20
J_SATA_2
21
FAN2
22
NVRAM_CLR
23
TPM
24
SAS_LED
25
IDSDM
26
HDD/ODD_PWR
27
FP_USB

Disabling a forgotten password

The system's software security features include a system password and a setup password. The password jumper enables the password
features or disables them and clears any passwords currently in use.
Prerequisite
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Steps
1
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2
Open the system.
3
Move the jumper on the system board jumper from pins 4 and 6 to pins 2 and 4.
4
Close the system.
The existing passwords are not disabled (erased) until the system boots with the jumper on pins 2 and 4. However, before you assign a
new system and/or setup password, move the jumper back to pins 4 and 6.
NOTE:
If you assign a new system and/or setup password with the jumper on pins 2 and 4, the system disables the new
passwords the next time it boots.
5
Reconnect the system to its electrical outlet and turn on the system, including any attached peripherals.
6
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
7
Open the system.
8
Move the jumper on the system board jumper from pins 2 and 4 to pins 4 and 6.
9
Close the system.
10
Reconnect the system to its electrical outlet and turn on the system, including any attached peripherals.
11
Assign a new system and/or setup password.
102
Jumpers and connectors
Description
8–pin power connector
SATA connector
Cooling fan connector
Password jumpers
Cooling fan connector
SATA SSD connector
Cooling fan connector
NVRAM password jumper
Trusted Platform Module connector
PERC card LED connector
Internal dual SD module connector
6–pin power connector
Front panel USB connector

Advertisement

Table of Contents
loading

This manual is also suitable for:

E34s001

Table of Contents