Monacor TXA-300HT, TXA-302HT - Hand-Held Microphone Manual

Overview

Applications

The dynamic hand-held microphones TXA-3..HT with integrated transmitter serve for wireless transmission of speech or vocals to receivers operating on the same radio frequency respectively. The range is approx. 30cm and depends on the local conditions.
The microphones are especially provided for the operation with the active systems of the series TXA-3.. from MONACOR which are equipped with one or two receiving parts:

Conformity and approval

Herewith, MONACOR INTERNATIONAL declare that the units TXA-300HT and TXA-302HT are in accordance with the basic requirements and the other relevant regulations of the directive 1995/5/EC. The declaration of conformity can be found in the Internet via the MONACOR INTERNATIONAL home page (www.monacor.com). The units are licence-free and generally approved for operation in EU and EFTA countries.

Important Notes

• The microphone is suitable for indoor use only. Protect it against humidity and heat (admissible ambient temperature range 0–40°C).
• For cleaning only use a dry, soft cloth, by no means chemicals or water.
• No guarantee claims for the microphone and no liability for any resulting personal damage or material damage will be accepted if the unit is used for other purposes than originally intended, if it is not correctly operated or not repaired in an expert way.

If the microphone is to be put out of operation definitively, take it to a local recycling plant for a disposal which is not harmful to the environment. Do not put exhausted batteries/defective rechargeable batteries into the household rubbish but take them to a special waste disposal (e. g. collective container at your electrical supply shop).

Setting into Operation

1. Unscrew the battery compartment cover (3). Place a 9V battery – with the positive and negative connections as shown in the figure – on the battery contacts. Screw on the cover again.
2. To switch on the microphone, set the switch POWER (2) to the upper position ON. The LED LOW-BAT (1) will shortly flash in red colour and then will be extinguished.
   If the LED permanently shows red after switching-on or during operating, the battery is almost exhausted.
3. To switch off the microphone after the operation, set the switch POWER to the lower position.
   If the microphone is not used for a longer time (e.g. more than a week), remove the battery. Thus, the microphone will not be damaged in case the battery should leak.

Specifications

Subject to technical modification.