Using The Work Light - Schumacher RUGGED SBX 461 Manual

3.2 Charging the internal battery
Charge the unit as soon as possible after use. Never completely discharge the
battery. Use a 2 A USB charger (not included), or a 2 A USB charging port to
quickly recharge the booster. Using a charger with less than 2 A will increase
charge time.
1. Plug the USB end of the charging cable into the input port. Next, plug the
USB end of the charging cable into a charger's USB port.
2. Plug your charger into a live AC or DC power outlet.
3. Approximate time to fully charge the booster (with 2 A charger):
SBX461:
SBX462:
SBX463:
SBX464:
4. When the unit is fully charged, all four white LEDs turn solid for a short
time, and then shut off.
5. When the battery is fully charged, disconnect your charger from the outlet,
and then remove the charging cable from the charger and the unit.
3.3 Charging the internal battery while driving
You may also charge the internal battery while driving, using the 12 V DC car
charger (included):
1. Make sure the car is running.
2. Plug the 12 V DC adapter cable into the unit's 12 V input socket.
3. Insert the other end of the accessory cable into the vehicle's accessory
outlet.
4. Approximate time to fully charge the jump starter:
SBX461:
SBX462:
SBX463:
SBX464:
5. When the unit is fully charged, all four white LEDs turn solid for a short
time, and then shut off.
6. When the battery is fully charged, disconnect your charger from the power
source and then remove the charging cable from the charger and the unit.
NOTE: Completely disconnect the charger cable when the engine is not running.
4. USING THE WORK LIGHT
Position the jump starter on a flat, stable surface near the intended work area.
Ensure the battery clamps are securely clipped on the storage holders.
1. Press twice and hold the Power/Light button on the front of the unit to
activate the steady mode, press once to cycle through the following modes:
- Steady glow;
- Flash for an SOS signal;
- Flash in strobe mode
2. When finished using the work light, press twice and hold the button for
0,75 second, to turn off the work light.
3. Recharge the unit as soon as possible after each use.
NOTE: Recharge the unit immediately when all battery status LEDs are off.
4-5 hours
5-6 hours
6-7 hours
7-8 hours
2 hours
3 hours
3.5 hours
4 hours
- 5 -
EN