Z-Wave PSG01 Quick Start Manual

Z-Wave Smoke Sensor PSG01
The Z-Wave Smoke Sensor PSG01 is designed to give early warning of
developing fires by giving off the alarm sounds from its build-in alarm
horn, based on Z-Wave TM technology.
It is the Z-Wave TM plus product, it support the security, OTA... Those
newest features of the Z-Wave
communication protocol designed for home automation, specifically to
remotely control applications in residential and light commercial
environments. The technology uses a low-power RF radio embedded or
retrofitted into home electronics devices and systems, such as lighting,
home access control, entertainment systems and household appliances.
This product can be included and operated in any Z-Wave
with other Z-Wave TM certified devices from other manufacturers and/or
other applications. All non-battery operated nodes within the network
will act as repeaters regardless of vendor to increase reliability of the
network.
The device adopt the Z-Wave
network system is all made by Z-Wave
network system will have the advantages as below.
Concurrent multi-channel support reduces external interference.
•
TM technology. Z-Wave TM
TM 500 series chip, when your Z-Wave
TM 500 series devices. The
Better RF range, improve about 10 meters in indoor.
•
Support 100 Kbps transmit speed, speed up communication.
•
Add to/Remove from Z-Wave
There is one button on the device. It can be used to add, remove, reset
from Z-Wave
In the first time, add the device into the Z-Wave
make sure the primary controller is in the add mode. And then insert
battery to power on the device. Press the button once to start the NWI
(Network Wide Inclusion) mode. And it should be added in 5 seconds.
Notice: Including a node ID allocated by Z-Wave
"Add" or "Inclusion". Excluding a node ID allocated by Z-Wave
is a wireless
Controller means "Remove" or "Exclusion".
Function
Add
TM network
Remove
TM
Reset
1
TM
TM network.
Description
1. Have Z-Wave TM Controller entered inclusion mode.
2. Pressing button three times within 1.5 seconds to
enter the inclusion mode.
3. After add successful, the device will wake to
receive the setting command from Z-Wave
Controller about 20 seconds.
1. Have Z-Wave TM Controller entered exclusion mode.
2. Pressing button three times within 1.5 seconds to
enter the exclusion mode.
Node ID has been removed.
Notice: Use this procedure only in the event
that the primary controller is lost or
otherwise inoperable.
1. Pressing button four times within 1.5 seconds and
do not release the button in the 4
Network
TM network. First,
TM Controller means
TM
TM
th pressed, and