EH-DS-01 Door/Window Sensor Installation Guide
Introduction
Z-Wave Door/Window sensors are designed to secure the perimeter of the residential premise, and provide the
ability to add various automation services. The Z-Wave Door/Window sensor, which consists of a magnet that
attaches to a door or window, will communicate door events to the home security system. When the magnet is
moved away from the sensor, a signal will be sent to the control panel that communicates the changed state to the
security system. Signals can also be used to activate a chime or convenience lighting based on system settings.
Specification
Frequency
Battery Type
Operating Temperature
Storage Temperature
Operating Air Range
Dimension
Add (Inclusion) Sensor
For Adding in (Inclusion) a network: Put the Z-Wave Interface Controller into "Add (Inclusion)" mode, and
following its instruction to add EH-DS-01 to your controller. This Door/Window sensor needs to be included
before installation.
Open the device
1.
. (Figure 1)
2.
Pressing the function button three times.
CR123A BatteryFunction Button
3.
Red led will blink three times while inclussion the network successful (Figure 2).
Red LED Indictor
4.
If inclussion failed, the sensor will go into sleep mode. To wake the sensor again, you
need to use magnet or tamper (Figure 3) to trigger a Adding (Inclusion) process, and then sensor will repeat
steps from 3 to 4.
908.42 / 908.40 / 916.00 MHz
CR123A Battery 1 PCS
C to 50 C (32° F - 122° F)
C to 60 C (-4° F - 140° F)
Up to 148 feet line of sight
Device: 94.5 mm x 24.3 mm x 22.4 mm
Magnet: 46 mm x 12.8 mm x 13.3 mm
Figure 1
Figure 2
Figure 3