Z-Wave ZWN-BPC Installation Instructions

INSTALLATION INSTRUCTIONS

Ceiling Mounted
PIR Motion Sensor
SPECIFICATIONS
Power Supply...................................................................2AA batteries
PIR Sensitivity Adjustment...................................25%/50%/75%/100%
Test Mode...................................................................................15 sec.
Operation Temperature...........................................................32-104°F
PIR Detection Coverage..................................................... Up to 600ft
Z-Wave Frequency..................................................... 908.42MHz(US)
RF Range......................................Up to 131 feet line of sight between
the Wireless Controller and the closest Z-Wave receiver module.
FEATURE
Adopt wireless RF technology
360 degree ceiling mounted cover up to 600ft
Low battery detection
Adjustable PIR Sensitivity
LED motion indicator
Support Z-Wave associations, sending commands up to 5 associated
Z-Wave devices
For indoor use only
DESCRIPTION
The PIR Motion Sensor ZWN-BPC is a Z-Wave enabled device and is
fully compatible with other Z-Wave certified device from other manufacturers
and/or other applications. This device is typically used in conjunction
with the ZWN-BDS to monitor the environment and provide hand-free
lighting control, it can also trigger a Z-Wave enabled alarm when motion
is detected.
This sensor acts as a security device by detecting changes in infrared
radiation levels. when some body moves within or across the detection
of coverage, one triggering signal will be transmitted to associated
Z-Wave devices.
COVERAGE PATTERN
The ZWN-BPC provides a 360° coverage pattern, up to 600 square
feet. The coverage shown represents walking motion at a mounting
height of 8 feet( See Figure 1 ). For building spaces with lower levels
of activity or with obstacles and barriers, coverage size may decrease.
- 01-
ZWN-BPC
8 ft
Typical
desk-top
level
13 ft
PLACEMENT
Place of PIR Motion Sensor:
It is very important to place the sensor with 6-7 feet from the primary
location, at least 8 feet away from the possible false triggering area.
2
Hotel Room :
2
Air-conditioner
Private Office :
INSTALLATION
Figure 1
7 ft 3 ft 0 3 ft 7 ft 13 ft
Bath Room
PIR Motion Sensor
Sitting Spot, a Chair or a Coach
Figure 2
PIR Motion Sensor
8 to 9 feet
Air Vent
Figure 3
-02-
1.The PIR Motion Sensor consists of two parts: Attachment Base and
Motion Sensor.
2.Place Attachment Base on ceiling by using both screws and adhesive pad.
3.Insert the two AA batteries noting the proper orientation.
26ft
8m
4.Lock the Motion Sensor by twisting onto the base.
Attachment Base
Motion Sensor
ADJUSTMENT
DIP Switch
Sensor Sensitivity Range
Adjustable: 25%/50%/75%/100%
DIP Switch PIR Sensitivity
OPERATION
Adding to Z-Wave network
At the back of Motion Sensor, there is a program button which is used
to add/remove and associated with other Z-Wave devices.
-03-
Ceiling
Adhesive Pad
Screw
Figure 4
Program Button
25%
50%
75%
100%