Table of Contents
Advertisement
7.2.5
n
0311767_HWH_32-129_II_UKUK_V2.4, 2020-01-31
Note
The leak tray must have an appropriate waste water drain and must be at least 5 cm
deep with a length and width at least 5 cm greater than the diameter of the water heater.
Storage tank working clearances
For access to the storage tank, it is recommended that the following clearances are
observed:
•
All sides of the storage tank: 50 cm.
•
Above the storage tank (space for anode replacement): 100 cm.
Note
When installing the storage tank, be aware that any leakage can cause damage to the
immediate environment or floors below the level of the boiler room. If this is the case, the
water heater should be installed above a waste water drain or in a suitable metal leak
tray.
55
Advertisement
Table of Contents
