Download Print this page

U-Line U-29RW-00A User Manual & Service Manual page 10

Hide thumbs Also See for U-29RW-00A:

Advertisement

USER GUIDE
General Installation
LEVELING INFORMATION
1.
Use a level to confirm the unit is level. Level should be
placed along top edge and side edge as shown.
2.
If the unit
is not level,
add shims to
the corners of the unit as necessary.
3.
Confirm the unit is level after each adjustment and
repeat the previous steps as needed.
INSTALLATION TIP
If the room floor is higher than the floor in the cutout
opening, adjust the rear to achieve a total unit rear height
1⁄8
of
" (3 mm) less than opening's front height. Shorten
the unit height in the front by adjusting the front shims.
This allows the unit to be gently tipped into the opening.
Readjust the front to level the unit after it is correctly
positioned in the opening.
INSTALLATION
1.
Plug in the power/electrical cord.
2.
Gently push the unit into position. Be careful not
to entangle the cord or water and drain lines, if
applicable.
3.
Re-check the leveling, from front to back and side to
side. Make any necessary adjustments. The unit's top
surface should be approximately
the countertop.
4.
Install the anti-tip bracket.
5.
Remove interior packing material and wipe out the
inside of the unit with a clean, water-dampened cloth.
General Installation
1⁄8
" (3 mm) below
INSTALL DOOR HANDLE
In the literature package inside the unit, there is a handle
that was specially designed for this door.
1.
On the upper side of the door, opposite to the hinges,
there are 2 screws. Remove them.
2.
Line up handle to holes.
3.
Use the 2 screws to install handle.
10

Advertisement

loading