Advertisement
Before installation
3
01
Packaging Removal & Unit Placement
Before installation, check the extraction unit for damage.
All packaging must be removed before the unit is connected
to the power supply.
Please read all instructions in this manual before using
this extractor.
1. Move the unit to the location where it is going to be
installed and remove the outer packaging. This unit should
be installed in a well-ventilated area.
Ensure that 500 mm space is available around any vented
panels on the extractor to ensure adequate airflow.
2. Check the filter is located in its correct position before
replacing the lid and securing the clips
Caution
Do not block or cover the airflow and motor
cooling ports on the unit, as this severely restricts airflow
and may cause damage to the unit.
Caution
Under no circumstances should the exhaust
outlet/s be covered as this will restrict the airflow and cause
overheating.
Advertisement
