Danby DWC040A3BSSDD Owner's Use And Care Manual page 12

Occasionally, a problem may arise that is minor in nature, and a service call may not be necessary. Use this troubleshoot-
ing guide for a possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby's
Toll Free Number 1-800-263-2629 for assistance.
Problem
No power
Cabinet temperature is too high.
Condensation on the cabinet,
doors or fl oor.
TROUBLESHOOTING GUIDE
Possible Cause
A fuse in your home may be
blown or the circuit breaker
tripped.
Power surge.
Plug not fully inserted into the wall
outlet.
Temperature setting.
Door not shut properly or opened
excessively.
Interior lights toggled on.
Recently added a large quantity of
warm bottles to the cabinet.
High humidity conditions in the
home.
Door not shut properly or opened
excessively.
What to do
Replace fuse or reset circuit
breaker.
Unplug the wine cooler, wait a few
seconds and then plug it back in
Make sure the 3-prong plug is fully
inserted into the outlet.
Verify the temperature control
setting. Adjust if neccessary.
Ensure that the door is fully closed
and that the gasket is sealing
against the cabinets. Open the
doors only as needed and for short
periods of time.
The interior lights are intended for
temporary lighting of cabinets for
display purposes only. They are not
intended to be left on for prolonged
time periods.
Limit the quantity of warm bottles
being introduced to the cabinet at
the same time. Attempt to stagger
the load introduction if possible.
The condensation will subside once
humidity conditions return to nor-
mal.
Ensure that the door is fully closed
and that the gasket is sealing.
against the cabinets. Open the
door only as needed and for short
periods of time
9