Function Turning On The Unit - PRESIDENT George II Owner's Manual

14) F ~ LOCK
F
(short press)
set/validate functions (see for example § DUAL WATCH page 48).
Allows to
This key pressed alone don't have any use.
See § FREQUENCY BAND SELECTION page 50.
LOCK
(long press)
Long press F (14) keys to activate/deactivate
the function is active, " " appears on the display.
15) ECHO ~ ECHO SETTING
ECHO
(short press)
Press the ECHO key (15) to activate/deactivate
LED turns red.
ECHO SET
(long press)
Long press ECHO key (15) to set
LED blinks.
Turn the CH rotary knob (4) or use the UP/DN keys (19) on the microphone
to alternately select "ECHO LEVEL" or "ECHO DELAY" in the list.
Ratate PUSH knob (6) to set the selected feature. There are 32 DELAY levels,
default: 16. There are 32 "LEVEL", default: 13. LCD shows selected "DELAY"
level or selected "LEVEL".
16) CLARIFIER
The function CLARIFIER (16) allows a frequency deviation during LSB/USB
reception in order to improve the clearness of your correspondent's voice.
17) USB CHARGING SOCKET
The USB socket (17) can be used to charge smartphones, tablets or other
rechargeable devices with 5 V - 2.1 A.
18) PTT (Push To Talk)
transmit
Transmission key, press to
listen to
to an incoming communication,
TOT (Time Out Timer)
If the transmission using PTT switch (18) or VOX function is longer than 3
the KEY LOCK function. When
the ECHO function.
ECHO VOLUME level and ECHO TIME. The
a message, is displayed and release
disappears.
minutes, the display starts blinking and the transmission ends. A beep will
sound until the PTT switch (18) key is released.
19) UP/DN KEYS ON MICROPHONE
Press UP/DN keys (13) on the microphone to
increase and DN to decrease
See ROTARY KNOB page 46.
20) 6 PIN MICROPHONE PLUG
The plug is located on the front panel of the transceiver and makes the
setting of the equipment into the dashboard easier.
See Cabling Diagram page 83.
A) DC-POWER TERMINAL (13.2 V)
B) ANTENNA CONNECTOR (SO-239)
C) JACK FOR EXTERNAL OPTIONAL SPEAKER (8 Ω, Ø 3.5 mm)
D) PA SPEAKER JACK (8 Ω, Ø 3.5 mm)
E) JACK FOR OPTIONAL VOX MICROPHONE (Ø 2.5 mm)
C) FUNCTIONS TURNING ON THE UNIT
1) FREQUENCY BAND SELECTION
(Configuration: EU; PL; d; EC; U; In)
The frequency bands have to be chosen according to the country of use.
Don't use any other configuration. Some countries need a user's licence.
See table page 85.
1. Turn on the power while pressing the F key (14). The letter corresponding to
the current configuration is blinking.
2. In order to change the configuration, use the CH rotary knob (4) on the unit
or the UP/DN keys (19) on the microphone.
3. When the configuration is selected, press the F key (14) during 1 second.
The letter corresponding to the configuration is continuously displayed and
a confirmation beep sounds.
4.
At this point, confirm the selection by switching off the transceiver and then
switching it on again.
See the frequency bands table at pages 80 to 82 / configuration table
page 84.
50
(short press)
change the channel. UP to
the channel.