Tilt-Up Deck Adjustable Stop - Walker B23 Operator's Manual

Table of Contents

Maintenance Instructions

Adjustments

Tilt-Up Deck Adjustable Stop*

When the carrier frame hinge joint is properly

ad justed, the deck lock levers should move in and

out of the engaged and disengaged positions

freely. All four (4) hitch pins used for height adjust-

ment should sit flush on the washers above the

deck pin bushing. On a level surface, if any pin is

sticking up (likely the front pins), tighten the oppo-

site side or loosen the same side to lower the pin.

Adjustments are made by loosening the jam nut

and tightening or loosen ing the set screws on the

Deck Mount Pivot Brack ets. Retighten the jam nut

when the adjustment is complete.

* Does not apply to DS60 Deck

Jam Nut

Set Screw

Tilt-Up Deck Adjustable Stop

B23

Table of Contents