C.P. Electronics MWS6-PRM-VFC-LV Product Manual

MWS6-PRM-VFC-LV & MWS6-PRM-VFC-LV-NC
Ceiling mounted Microwave pres/abs detector + volt free contact 12-24V AC/DC
Front features
Mounting Bezel
Back features
Retaining Spring
Switched
Output Connector
Retaining Spring
Sensor Lens
which covers...
Microwave Sensor
IR Receiver
Light Level Sensor
Status LEDs
Power Input &
Switch Input
+
-
Product Guide
The MWS6-PRM-VFC-LV Microwave presence detector
provides automatic control of low voltage loads including
lighting and BMS systems with optional manual control.
The MWS6-PRM detects movement using a highly
sensitive microwave detector. This works by emitting low
power microwave signals and measuring the reflections as
the signals bounce off moving objects.
This unit provides an isolated voltage free contact output.
Functioning as a presence detector, the unit can turn lights
on when a room is occupied and off when the room is
empty. Optional settings allow lights to be turned off in
response to ambient daylight.
All functionality is fully programmable using an IR handset.
Two variants are available.
MWS6-PRM-VFC-LV
MWS6-PRM-VFC-LV-NC
Microwave Sensor
Detects movement within the unit's detection range,
allowing load control in response to changes in occupancy.
IR Receiver
Receives control and programming commands from an
IR (infrared) handset.
Light Level Sensor
Measures the overall light level in the detection area
Status LEDs
The LED flashes Red to indicate the following:
Walk Test LED active
Valid setting received
Output Connector
Connection to a switched load.
Power Input & Switch Input Connector
Used to connect power to the unit and two input terminals
that can be used to manually override the lights on or off.
Overview
Ceiling mounted microwave
pres/abs detector + volt free
contact 12-24V AC/DC.
Ceiling mounted microwave
pres/abs detector + volt free
contact 12-24V AC/DC,
normally closed fail safe
operation.
Features
when movement is detected