Beko GN141632ZXBRN User Manual page 5

Important instructions regarding safety and environment
Do not tuck the power cord under the
product or to the rear of the product.
Do not put heavy items on the power
cord. The power cord should not be bent,
crushed, and come into contact with any
heat source.
Do not use an extension cord, multi-plug
or adaptor to operate your product.
Portable multi sockets or portable power
supplies may overheat and cause fire.
Thus, do not have a multi-plug behind or
in the vicinity of the product.
The plug shall be easily accessible. If
this is not possible, a mechanism that
meets the electrical legislation and that
disconnects all terminals from the mains
(fuse, switch, main switch, etc.) shall be
available on the electrical installation.
Do not touch the plug with wet hands.
When unplugging the appliance, don't
hold the power cord, but the plug.
1.4 Handling Safety
This product is heavy, do not handle it by
yourself.
Do not hold the product from its door
while handling the product.
Be careful not to damage the cooling
system and the pipes while handling the
product. Do not operate the product if
the pipes are damaged, and contact an
authorized service.
1.5 Installation Safety
Contact the Authorized Service for
the product's installation. To prepare
the product for installation, see the
information in the user guide and make
sure the electric and water utilities are as
required. If the installation is not suitable,
call a qualified electrician and plumber
to have them make the necessary
arrangements. Otherwise, electric shock,
fire, issues with the product or injuries
may occur.
Check for any damage on the product
before installing it. Do not have the
product installed if it is damaged.
Place the product on a level and
hard surface and balance with the
adjustable legs. Otherwise, the
refrigerator may tip over and cause
injuries.
The product shall be installed in a
dry and ventilated environment.
Do not keep carpets, rugs or similar
floor covers under the product. This
may cause risk of fire as a result of
inadequate ventilation!
Do not block or cover ventilation
holes. Otherwise, power consumption
may be increased and damage to your
product may occur.
Do not connect the product to supply
systems such as solar power supplies.
Otherwise, damage to your product
may occur as a result of the abrupt
voltage fluctuations!
The more refrigerant a refrigerator
contains, the bigger its installation
room shall be. In very small rooms,
a flammable gas-air mixture may
occur in case of a gas leak in the
cooling system. At least 1 m3 of
volume is required for each 8 grams
of refrigerant. The amount of the
refrigerant available in your product is
specified in the Type Label.
The installation place of the product
shall not be exposed to direct sunlight
and it shall not be in the vicinity of a
heat source such as stoves, radiators,
etc.
If you cannot prevent installation of the product
in the vicinity of a heat source, you shall use a
suitable insulation plate and the minimum distance
to the heat source shall be as specified below.
- At least 30 cm away from heat sources such
as stoves, heating units and heaters, etc.,
- And at least 5 cm away from electric ovens.
3 /30 EN
Refrigerator / User Manual