Advertisement
Quick Links
DL4 DS Link Fujifilm TTL Converter Ikelite
FT1 Hotshoe Kit
Product # 46082
Included in the Box
•
DL4 DS Link Fujifilm TTL Converter # 46083
•
FT1 Fujifilm TTL Hotshoe # 46081
Important Notices
The DL4 DS Link is not compatible with other
»
manufacturers' strobes.
Use of two strobes requires a dual sync cord. Two
»
strobes cannot be controlled by individual converters
even if the housing is equipped with two bulkheads.
Installation and Use
Installing the FT1 TTL Hotshoe
1.
Depress the tab on the manual hotshoe connector and
gently pull connector ends apart to remove the housing's
manual hotshoe.
2.
Align TTL hotshoe and bulkhead connector ends and
push together until tab clicks into place.
3.
Push hotshoe forward into camera's hotshoe mount.
Make sure that the hotshoe is all the way forward to
ensure proper connection.
The FT1 TTL Hotshoe is only intended for use with
»
compatible Ikelite brand housings.
Testing the Housing
1.
Assemble the housing without a camera installed.
Ensure that a waterproof bulkhead cap is in place on the
bulkhead.
2.
Submerge the housing in fresh water for several minutes.
3.
Remove the housing from water and dry the outside of
the housing with a clean, lint-free cloth.
4.
Look through the back of the housing for signs that water
has entered the housing. Signs include fogging or water
droplets.
5.
We recommend making at least one dive without a
camera installed to ensure waterproof operation.
Attaching the Converter
1.
Remove connector protectors and bulkhead caps from
each connection.
Retaining ring
Plug o-ring
2.
Apply a very thin, even layer of lubricant on all threads,
sealing surfaces, and the exposed portion of the plug
o-ring. Do not allow lubricant to get into the pins and
receptacles of the plug or bulkheads.
3.
Align plug and insert into the housing bulkhead. Each
male pin mates with a female receptacle. Failing to line up
the contacts properly before tightening may result in
damage to the converter plug and/or housing bulkhead.
4.
Hand-tighten the retaining ring.
Mode button
LED indicator
MADE
IN USA
DL1 DS LINK
Bulkhead
Advertisement
Summary of Contents for Ikelite DL4
- Page 1 • FT1 Fujifilm TTL Hotshoe # 46081 Attaching the Converter Important Notices Remove connector protectors and bulkhead caps from The DL4 DS Link is not compatible with other » each connection. manufacturers’ strobes. Mode button Retaining ring LED indicator Use of two strobes requires a dual sync cord.
- Page 2 Shooting with TTL Strobe Exposure This Ikelite product is warranted against any manufacturing Turn strobe on. When turned on the DL4 DS Link will be defects for a period of one (1) year from the original date in TTL mode. The LED indicator glows blue in TTL mode.