Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Diamond G17/F15A4-AGA
Summary of Contents for Diamond G17/F15A4-AGA
- Page 1 08/2016 Mod: G17/F15A4-AGA Production code: 373070 AGA...
-
Page 2: Table Of Contents
INDEX I. COMBINING APPLIANCES / TABLES ........................... 2 II. DATAPLATE and TECHNICAL DATA ............................. 19 III. GENERAL INSTRUCTIONS ..............................20 IV. THE ENVIRONMENT ................................21 V. INSTALLATION ..................................21 1. REFERENCE STANDARDS ..............................21 2. UNPACKING .................................... 21 3. POSITIONING ..................................22 4. -
Page 3: Dataplate And Technical Data
II. DATAPLATE and TECHNICAL DATA IMPORTANT This manual contains information relevant to various appliances. See the appliance dataplate located under the control panel in order to identify the appliance (see fig. above). TABLE A - Gas/electric appliance technical data MODELS +7FRGD1B00 +7FRGH2B00 +7FRGD1BF0... -
Page 4: General Instructions
III. GENERAL INSTRUCTIONS • Carefully read the instruction handbook before using the appliance. • After installation keep the instruction handbook for future consultation. • FIRE HAZARD - Keep the area around the appliance clear and free from combustible materials. Do not keep flammable materials in the vicinity of the appliance. -
Page 5: The Environment
1. REFERENCE STANDARDS IV. THE ENVIRONMENT • Install the appliance in accordance with the safety regulations and local laws of the country where used. • AUSTRALIA: this appliance shall be installed only by 1. PACKING authorised persons and in accordance with the Packing materials are environment friendly and can manufacturer’s installation instructions, local gas fitting be stored without risk, or burned in a special waste... -
Page 6: Fume Exhaust And Ventilation
3.1. COMBINING APPLIANCES 5. CONNECTIONS • (Fig.1A) Remove the control panels of the appliances by • Any installation work or maintenance to the undoing the 4 fixing screws. supply system (gas, electricity, water) must only • (Fig.1B) Remove the fixing screw nearest the control be carried out by the utility company or an panel, from each side to be joined. - Page 7 5.1.7. CHECKING THE PRIMARY AIR (tube version - fig. 3C) 5.1.4 GAS PRESSURE REGULATOR To adjust, proceed as follows: If the gas pressure is higher than that specified or is difficult • Loosen fixing screw “C” and adjust bushing “D” at distance to regulate (not stable), install a gas pressure regulator (ac- “H”...
-
Page 8: Gas Appliance Conversion / Adjustment
5.2. ELECTRIC APPLIANCES 5.2.1. ELECTRICAL CONNECTION (Fig. 4A -Table A). IMPORTANT! Before connecting, make sure the mains voltage and frequency match that given on the dataplate. • To access the terminal board, remove the appliance con- trol panel by removing the fixing screws (fig. 4A 1-2). •... -
Page 9: Instructions For The User
INSTRUCTIONS During cooking, manually remove any VI. INSTRUCTIONS FOR THE cooking residuals in the oil. The prolonged presence of these residuals alters the taste and odour of the oil, USER reducing its useful life. For a quick and good measurement of the degree of oil deterioration, use litmus paper (strips) available on the 1. - Page 10 Switch-on (7 L) Lighting (40 L Tubes) Control knob “A” has the following positions: Control knob “A” has the following positions: Knob A: Knob A: Control knob “A” has the following positions: “Off” position “Pilot ignition” position Temperature values pilot ignition max.
- Page 11 1.2. ELECTRIC MODELS 1.3. ELECTRIC MODEL WITH ELECTRONIC CONTROL ON/OFF key Switching on temperature setting key • Pour the oil in the tank up to the max. level indicated by the left basket program start key special reference notch obtained on the rear wall of the tank. right basket program start key •...
- Page 12 1.6. PROGRAMMING (for the 7 and 14 L Counter Top versions) • position a bowl for collecting the oil at the drain valve (B) 5 different cooking programs (keys “10”) can be stored: the (fig.2); above the valve there is a small knob (A) which desired cooking temperature and, depending on the version, must be pressed (1) and slowly turned (2) clockwise to 1 or 2 cooking times can be stored in each program (in the...
-
Page 13: Cleaning
2. OTHER SURFACES VII. CLEANING HEATED TANKS/CONTAINERS (daily) Clean the appliance tanks or containers using boiled water, adding soda (degreasing) if necessary. Use the accessories IMPORTANT! (optional or supplied) specified in the list to eliminate Before carrying out any cleaning operation, disconnect the encrustations or food deposits. -
Page 14: Cleaning Fryers With Internal Heating Elements (18 Litres)
5. CLEANING FRYERS WITH INTERNAL VIII. MAINTENANCE HEATING ELEMENTS Clean the tank, operating as follows: 1.MAINTENANCE • wait until the appliance has cooled; • drain the oil from the tank by means of the special cock. All the components requiring maintenance are accessible •... -
Page 15: List Of Components
1.2. INSTRUCTIONS FOR REPLACING COMPONENTS (to be carried out only by a specialised installer) - Gas valve • Remove the control panel, undoing the fixing screws. • Unscrew the pilot burner pipe and thermocouple. • Undo the screws fixing the flange to the valve. •...