Assembly Instruction - Profi-pumpe GB021112-4 Operating Instructions Manual

3. ASSEMBLY INSTRUCTIONS
z Remove all parts carefully from the
packaging and place them on a flat
surface.
z The LEDs are pre-assembled in the
fountain body.
z Depending on the model, the
connecting cable has one or more
cable plugs for connecting the LEDs.
z Connect each cable plug to an LED.
z Tighten the closing caps on the LED
connectors.
z Connect the power cable to the
adapter.
z Fill clean water into the reservoir.
Note: Distilled water is recommended to reduce mineral deposits and bacteria buildup.
z Before turning on the pump, make sure all connections are properly connected. There should be
no kinks in the cables or waterhose.
z Now plug the power supply into the electrical outlet.
If installed correctly, the water will begin to flow.
Note: When connected to the power supply, the pump and LED lighting are switched on.
When the power is disconnected, the pump and LED lighting are switched off.
Please note that some water may splash out of the well when the pump starts up for the first
time. If necessary, move the water quantity regulator on the pump in the "-" direction.
When all connections are complete, place
the pump at the bottom of the fountain.
Route the power cable to the outside.
Powercable
Problem: Uneven water distribution or water splashes in the fountain area.
Remedy: During the first start-up, uneven water distribution may occur. In such cases,
we recommend that you check and adjust the level accuracy of the fountain and adjust the
water flow (see page 12).
Power cable
LED cable
Waterhose
IMPORTANT!
Adapter
Hose
Pump
Fill the fountain with water. The pump must
be completely submerged in water, otherwise
the pump will be damaged.
English 3
LEDs
Closing caps
Cable plug
Connecting cable