Installation - Nevir NVR-4354 DD Instructions For Use Manual

INSTALLATION

• Install the appliance away from heat sources. Installation in a hot
environment, direct exposure to the sun or installation near heat sources
(heaters, radiators, cookers) will increase power consumption and should
therefore be avoided.
• If this is not possible, the following minimum distances must be respected:
• 30 cm from coal or paraffin stoves;
• 3 cm from electric and/or gas stoves.
• Fit the spacers (if supplied) on the rear of the condenser positioned at the
back of the appliance (see figure).
• To optimize appliance efficiency, leave a 5 cm gap above the appliance
and make sure that adjacent kitchen units are sufficiently distanced to allow air
circulation.
• Install the appliance in a dry, well-ventilated place, and ensure it is level, using
the front adjustment feet if necessary.
• Clean the interior.
• Fit the accessories.
Electrical connection
• Electrical connections must be made in accordance with local regulations.
• Voltage and power consumption are indicated on the rating plate inside the
appliance.
• Regulations require that the appliance is earthed.
The Manufacturer declines all liabilities for injury to persons or animals or
damage to property resulting from failure to observe these regulations.
• If the plug and socket are not of the same type, have the socket replaced by
a qualified electrician.
• Do not use extension leads or adapters.
Disconnecting the appliance
It must be possible to disconnect the appliance by unplugging it or by means
of a two-pole switch fitted up line of the socket
25