Change Supervisor /User Password - Lanner electronics EM-566 Series Manual

3.10 C S
HANGE
When you select this function, a message as below will appear on the screen:
© 2001 American Megatrends, Inc. All Rights Reserved
Standard CMOS setup for changing time, date, hard disk type, etc.
ESC : Exit ↑↓ : Sel F2/F3 : Color F10 : Save & Exit
Type the password, up to six characters in length, and press<Enter>. The password typed now
will replace any previously set password from CMOS memory. You will be prompted to confirm
the password. Retype the password and press<Enter>. You may also press<Esc> to abort the
selection and not enter a password.
To clear a set password, just press<Enter> when you are prompted to enter the password. A
message will show up confirming the password will be disabled. Once the password is disabled,
the system will boot and you can enter Setup without entering any password.
When a password has been set, you will be prompted to enter it every time you try to enter Setup.
This prevents an unauthorized person from changing any part of your system configuration.
Additionally, when a password is enabled, you can also have AMIBIOS to request a password
each time the system is booted. This would prevent unauthorized use of your
/U
UPERVISOR SER
AMIBIOS HIFLEX SETUP UTILITY
EM-566 Ver.A 2002-06-26
Standard CMOS Setup
Advanced CMOS Setup
Advanced Chipset Setup
Power Management Setup
PCI / Plug and Play Setup
Peripheral Setup
Enter new supervisor password:
Hardware Monitor Setup
Auto-Detect Hard Disks
Change User Password
Change Supervisor Password
Auto Configuration with Optimal Settings
Save Settings and Exit
Exit Without Saving
~ 40 ~
P
ASSWORD
AMI BIOS SETUP