Lanner electronics EM-561 Series User Manual page 35

LS/ZIP, HDD-0/HDD-1/HDD-2/HDD-3, SCSI, CDROM, LAN, and Disabled
Swap Floppy Drive : The default setting is "Disabled". This setting gives you an option to
swap A and B floppy disks. Normally, the floppy drive A is the one at the end of the cable and
drive B is at the other end. If you set this option to "Enabled", the Drive A will function as Drive
B, and vice-versa under the DOS.
Boot Up Floppy Seek : The defaults setting is "Disabled". When enabled, the BIOS will check
whether there is a floppy disk drive installed.
Boot Up NumLock Status : The default setting is "On". If set "Off", the cursor controls will
function on the numeric keypad.
Gate A20 Option : The default setting is "Fast". This is the optimal setting for the CPU card.
The other option is "Normal".
Typematic Rate Setting : The default setting is "Disabled". If enabled, you can set the
typematic rate and typematic delay.
Typematic Rate (Chars/Sec) : This setting controls the speed at which the system registers
the repeated keystrokes. The choices range from 6 to 30 Chars/Sec. The default setting is "6"
Chars/Sec.
Typematic Delay (M/Sec) : This setting controls the time between the display of the first and
second characters. There are four delay choices: 250ms, 500ms, 750ms and 1000ms. The
default setting is "250" ms.
Security Option : This setting controls the password in the main screen. The options are
"Setup" and "System". Select "Setup" and it will protect the Setup Utility settings from being
tampered with. Select "System" if you want to use password feature every time the system
boots up. The default setting is "Setup". You can create your password by using the
"SUPERVISOR/USER PASSWORD" utility on the main program screen.
OS Select For DRAM > 64MB : The default setting is "Non-OS2". Set to "OS2" if the system
memory size is greater than 64MB and the operating system is OS/2.
Report No FDD For WIN 95 : Select "Yes" to release IRQ6 when the system contains no floppy
drive , for compatibility with Windows 95 logo certification. In the Integrated Peripherals screen
select "Disabled" for the Onboard FDC Controller field.
Small Logo (EPA) Show: The default setting is "Enabled" which will display EPA logo (small) on
the screen during POST process.
Page: 31